From Conventional Single-Event Polymerization to Biomechanically Separated Polymerization: A Conceptual Framework for the Semi-Split Delayed Gap Closure Technique in Direct Bulk-Fill ResinComposite Restorations
DOI:
https://doi.org/10.47363/JDSR/2026(8)226Keywords:
C-Factor, Class I, Bulk-Fill Composite, emi- Split Delayed Gap Closure, Conventional, Time-Dependent Polymerization, Geometric, Confinement, Shrinkage Stress, Viscoelastic Relaxation, Posterior Composite Geometry, Single- Event Cure, Six-Stage SequenceAbstract
Background: Conventional composite placement comes down to three steps: the material is placed, it is cured once, and it ends up in a state of maximum
constraint. Every strategy currently used to manage shrinkage stress, whether incremental layering, low-shrinkage monomers, flowable liners, or soft-start
and pulse-delay curing, works by changing something inside that single middle step. None of them add a new one.
Objective: To describe the six-stage process behind the Semi-Split Delayed Gap Composite (SS-DGC) technique, set it against the three-stage conventional
sequence, and consider what a six-stage architecture actually changes mechanically that a three-stage one cannot.
Technique Rationale: SS-DGC introduces four stages between placement and final cure that the conventional sequence simply has no room for. These are:
cutting a gap that lowers the effective C-factor from roughly 5.67 to roughly 2.1 before any light exposure occurs; an initial low-intensity cure carried out
under that reduced constraint; a five-minute relaxation period that follows a Kohlrausch-Williams-Watts (KWW) stretched-exponential decay (τ ≈ 5 min,
β = 0.40–0.60); and closing the gap, which sets up a new, smaller constraint ahead of the final high-intensity cure.
Discussion: The six-stage sequence includes two changes in geometry, one genuine relaxation period, and two reactions that run on independent timelines.
None of which the three-stage conventional sequence has at all. Conventional technique reaches maximum constraint and maximum conversion at the
same moment. The SS-DGC reaches full cure with most of the restoration already relaxed, leaving only a small final gap-fill increment newly constrained.
Conclusion: Adding stages to a curing sequence is not the same as slowing down the stages that already exist. Whether this six-stage architecture’s lower
terminal stress state translates into a measurable clinical benefit is a separate question from the mechanistic case made here, and will need dedicated
experimental and clinical study.